| Capacity Struck | 194.9 yd3 (149 m3) |
| Heaped (2:1, Sae) | 280 yd3 (214 m3) |
| Payload | 89999.4 lb (40823 kg) |
| Structure | Flat floor configuration |
| Weight | 89999.4 lb (40823 kg) |
| Canopy Sheet | 06mm 0.24" 690 Mpa 1,00,000 psi tensile strength steel |
| Front Sheet | 10 mm 0.39" Outer, 12mm 0.47" Center, 1379 mPa 200,000 psi tensile strength steel |
| Side Sheet | 10 mm 0.39" 1379 Mpa 2,00,000 psi tensile strength steel |
| Floor Sheet | 16 mm 0.63" Outer, 19mm 0.75" Center, 1379 mPa 200,000 psi tensile strength steel |
| Loading Height | 23.5 ft in (7.2 m) |
| Service Brake Type | Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel. |
| Parking Brake Type | Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight. |
| Emergency Brakes | Oil-cooled, multiple disc front & rearAutomatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements. |
| Wheel Brake Locks | Switch-activated |
| Electric Dynamic Retarder (Max.) | 4476 |
| Max. Service Apply Pressure (Kpa) | 2750 psi (18960 kPa) |
| Total Friction Area Per Brake (Cm2) | 103729 |
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping. |
| Relief Pressure | Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-20685 kPa 3,000 psi |
| Hoist Time | Power-up loaded: 24 sec; Power-down: 14 sec; Float-down empty:24 sec |
| Turning Circle Diameter (Sae) | 105 ft in (32.1 m) |
| Reservoir | 250 gal (946.4 L) |
| Filtration | In-line replaceable elements |
| Suction | Single, full flow, 100 mesh |
| Hoist And Steering | Dual, in-line, high pressure |
| Pumps | Two pumps, single package, end of alternator |
